Sampling P9: Master/Total Effect; 9-1: Routing - Korg Electronic Keyboard Parameter Manual

Sampling P9: Master/Total Effect

Here you can select the effect types for the master
effects and total effects, and turn them on/off.
The master effects are output to the L/R bus. The total
effects are inserted in the L/R bus. If you want to use
these while sampling, set Source Bus to L/R.
For more information, please see the "Effect Guide,"
beginning on page 727.
9–1: Routing
9–1a
9–1b
9–1a: MFX
The master effect does not output the direct sound
(Dry). Adjust the "Return 1" and "Return 2" return
levels to return the signal to the L/R bus and mix it
with the L/R bus signal.
The master effects are stereo-in/out, but depending on
the selected effect type, the output may be monaural.
See "In/Out" on page 734.
MFX1
MFX1
This selects the effect type for master effect 1. Choose
from 000:No Effect – 185: Mt.BPM Dly // Mt.BPM Dly.
If you choose 000:No Effect, the output from the master
effect is muted.
Category/MFX Select menu
When you press the popup button, the Category/MFX
Select menu will appear, letting you select effects by
category. Use the tabs to select a category, and then
Sampling P9: Master/Total Effect
Note: When you sample, MFX1 On/Off, MFX2 On/Off,
TFX1 On/Off, and TFX2 On/Off are automatically
turned off. This is done so that the effect will not be
applied again (i.e., a second time) when you play back
the sample that was resampled with the MFX1/2 and
TFX1/2. (In the same way, the Bus Select (All OSCs
to) parameter will automatically be set to L/R.) Be
aware of this if you want to sample once again.
8–5b
select an effect within that category. Press the OK
button to execute your selection, or press the Cancel
button to cancel.
MFX1 On/Off
Switches the master effects 1 on/off. When off, the
output will be muted. This will alternate between on
and off each time it is pressed.
Separately from the settings here, you can use
[000...185]
control change #94 to turn master effects 1 and 2 off.
A value of 0 turns them off, and values of 1–127
restore the original setting. The global MIDI channel
specified by MIDI Channel (Global 1–1a) is used
for this message.
Return 1
This specifies the return level from the master effect to
the L/R bus (after which it passes through TFX1 and 2,
and is sent from L/MONO and R).
9–1: Routing
9–1PMC
9–1c
[Off, On]
[000...127]
611