Table of Contents
Advertisement
FX Balance
IFX: This controls the "Wet/Dry" balance of all insert
effects. A setting of +10 is Wet or –Wet, a setting of +0
leaves the settings of the combination unmodified, and
a setting of –10 is Dry.
MFX: This controls the MFX1 and 2 "Return." A setting
of +10 is 127, a setting of +0 leaves the settings of the
combination unmodified, and a setting of –10 is 000.
TFX: This controls the "Wet/Dry" balance of TFX1 and
2. A setting of +10 is Wet or –Wet, a setting of +0 leaves
the settings of the combination unmodified, and a
setting of –10 is Dry.
When you edit these settings, the change will occur
immediately in the sound, but the values of the
original combination parameters will not change
0–8: Audio Input/Sampling
0–7a
0–8a
0–8c
Here you can adjust the settings for the analog/digital
audio signal input (AUDIO INPUT, S/P DIF), and the
sampling-related settings for Combination mode.
As in Program mode, sampling in Combination mode
allows you to sample an incoming audio signal or to
sample a OASYS performance. The OASYS can also be
used as a 6-in 10-out effect processor.
For example, here are some ways you might use this.
• You can sample only an external audio source from
AUDIO INPUT (guitar, etc.) or S/P DIF while
listening to your performance (i.e., drum phrase)
that uses the KARMA function.
• You can play a combination that uses filters, effects,
or the KARMA function, and resample your
performance.
Combination P0: Play
until you save the combination. When you save the
combination, the values will be updated and these
sliders will be reset to 0.
▼ 0–7: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Combination. For more information, see
"Write Combination" on page 405.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
• 2: Copy From Program. For more information, see
"Copy From Program" on page 405.
0–8d
• You can sample your performance on the OASYS
together with an external audio source.
Using the control surface to adjust Audio Input
You can use the control surface to adjust the Audio
Input Send1 (to MFX1), Send2 (to MFX2),
PLAY/MUTE, Solo On/Off, Pan, and Level.
For more information, please see "0–9c: Audio Inputs"
on page 22.
The control surface will control the Global mode
settings if "Use Global Setting" is On (checked).
0–8: Audio Input/Sampling
0–8PMC
0–8b
331
Advertisement
Table of Contents
