Table of Contents
Advertisement
Program mode: HD-1
These External Setups are completely separate from
the Program. You can think of External mode as being
a separate control surface which just happens to share
OASYS's sliders, knobs, switches, and drum pads.
When you select an External Setup, it stays selected
even when you change Programs, or switch to Combi
or Sequencer modes. This makes it easy to select
different OASYS sounds without disrupting any
external MIDI control, and vice-versa.
Setup
This selects the Global setup for the knobs, sliders,
switches, and drum pads.
Note: this selection is not stored with the Program.
Knobs 1–8
MIDI Channel (1–8)
This read-only parameter shows the MIDI Channel
assigned to the knob. Each can send on a different
channel, if desired.
Gch means that the knob will transmit on the Global
MIDI Channel, as set in Global mode. This allows you
to re-direct any number of sliders, knobs, switches, and
pads to a different channel at once, without editing the
individual controls.
CC# Assign (1–8)
This read-only parameter shows the MIDI CC sent by
the knob.
Value (1–8)
This is the current value of the knob's MIDI CC.
Selected
Parameter
Information
0–9e
0–9e: RT/KARMA (Real Time
Knobs/KARMA)
This Control Assign (labeled R. Time Knobs/KARMA
on the front panel) setting lets you modulate Program
and Effects parameters with the eight knobs, and
24
Switches 1–16
MIDI Channel (1–16)
This read-only parameter shows the MIDI Channel for
the switch. Each can send on a different channel, if
desired.
Gch means that the slider will transmit on the Global
MIDI Channel, as set in Global mode.
CC# Assign (1–16)
[000...127]
This read-only parameter shows the MIDI CC sent by
the switch.
Switch Off/On (1–16)
When the switch is turned on, it sends a value of 127;
when it is turned off, it sends a value of 0.
Sliders 1–8 & Master Slider
[01...16, Gch]
MIDI Channel (1–8)
This read-only parameter shows the MIDI Channel for
the slider. Each can send on a different channel, if
desired.
Gch means that the slider will transmit on the Global
MIDI Channel, as set in Global mode.
CC# Assign (1–8)
[Off, 000...119]
This read-only parameter shows the MIDI CC sent by
the slider.
Value (1–8)
[000...127]
This is the current value of the slider's MIDI CC.
control KARMA with the switches and sliders.
Selected parameter information
When you select a KARMA Slider or Switch, this area
shows detailed information about its KARMA
parameter assignments.
[01...16, Gch]
[Off, 000...119]
[Off, On]
[01...16, Gch]
[Off, 000...119]
[000...127]
Advertisement
Table of Contents
