Table of Contents
Advertisement
Knobs 1–8
Knobs 1–4 all have dedicated functions which
correspond to MIDI CCs. Knobs 5–8 can be assigned to
a wide variety of functions, many of which also have
corresponding MIDI CCs.
When you move the knob, it will send the
corresponding MIDI CC to all Timbres on the Global
Channel. (To edit individual Programs, use Tone
Adjust instead.)
Also, when the CC is received via MIDI or generated
by KARMA, the knob value will change to match the
CC value.
Note that the Knob 1–8 settings of the individual
Programs do not apply in Combi mode.
Unless otherwise noted, "scaling" means that the
parameters are at their programmed values when the
controller is at 64, at their minimum when the
controller is at 0, and at their maximum when the
controller is at 127. For another look at this, see the
diagram below.
CC scaling of parameters
99
Parameter
Value
As Programmed
00
0
64
CC Value
Knob 1: CUTOFF (CC#74)
This knob scales the cutoff frequencies of Filters A and
B, and transmits and receives MIDI CC #74.
Knob 2: RESONANCE (CC#71)
This knob scales the resonance of Filters A and B, and
transmits and receives MIDI CC #71.
Knob 3: Filter EG Intensity (CC#79)
This knob scales the effect of the Filter EG on the cutoff
frequencies of Filters A and B. It also transmits and
receives MIDI CC#79.
Knob 4: EG Release (CC#72)
This knob scales the release time of the Filter and Amp
EGs, and transmits and receives MIDI CC#72.
Knobs 5–8
You can set knobs 5–8 to a wide variety of modulation
functions, using the Controller Setup page (P1–8).
Many of the functions scale a particular set of Program
parameters. All of the settings also correspond to MIDI
messages–usually CCs.
KARMA SCENES 1-8
KARMA Scenes
A KARMA SCENE includes the settings for all of the
KARMA SLIDERS and SWITCHES. Each Combi can
contain up to eight Scenes.
To select a Scene, just press its switch - you'll see all of
the KARMA SLIDERS and SWITCHES update
instantly to their new values.
KARMA SWITCHES 1-8
KARMA Switches
These switches control KARMA Performance or GE
(Generated Effect) Real-Time Parameters, as assigned
on the KARMA Perf RTP and GE RTP pages.
The switches indicate the current on/off status.
The parameters assigned to the switches and their
on/off status can be edited in the GE RTP page or the
KARMA Perf RTP page.
KARMA SLIDERS1-8
KARMA Sliders
These sliders control KARMA Performance or GE
Real-Time Parameters, as assigned on the KARMA
Perf RTP and GE RTP pages.
The current values are shown under the sliders. The
parameters assigned to the sliders and their value can
be edited in the GE RTP page or the KARMA Perf RTP
page.
Master Volume Slider
127
Master Volume
This controls the volume of the main stereo outputs,
after the Total Effects. It does not affect Individual
[000...127]
Outputs 1–8. For more information, see the diagram
"Master Volume" on page 338.
[000...127]
[000...127]
[000...127]
[000...127]
Combination P0: Play
0–9: Control Surface
[1...8]
[Off, On]
[000...127]
[000...127]
341
Advertisement
Table of Contents
