Table of Contents
Advertisement
Tip: In most of the preloaded drum kits, the following
types of drum instrument have the same Bus Select
settings.
Tip: Most of the preloaded drum kits use the same
basic Bus Select settings, as shown below:
Snares → IFX1
Kicks → IFX2
Toms → IFX3
Cymbals → IFX4
Percussion etc. → IFX5
FX Control Bus
For each key, you can select whether the signal will be
sent to FX Control bus (stereo two-channel) FX Ctrl1 or
2.
Normally you will leave this off, but you can use this
setting if you want to control an effect by playing a
specific key.
You can use this with the following effects:
Vocoders:
• 026: Vocoder
Gated Reverb Example
Global P5: Drum Kit
KEY: D3
(Snare)
Pan
[Random, L001...C064...R127]
Specifies the panning for each key.
L001 places the sound at far left, and R127 places the
signal at far right. With a setting of Random, the drum
sample will be panned randomly at each note-on.
Send1 (to MFX1)
Send2 (to MFX2)
For each key, specify the send levels to master effects 1
and 2.
These settings are valid when Bus Select (5–3b) is set
to L/R or Off. If Bus Select is set to IFX1–12, the send
level to master effects 1 and 2 will be determined by
the Program, Combination, or Sequencer mode P8:
Insert FX page parameters Send1 and Send2 which are
located after the sound passes through IFX1–12.
▼ 5–3: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Drum Kit. For more information, see
"Write Drum Kit" on page 689.
• 1: Copy Key Setup. For more information, see
"Copy Key Setup" on page 689.
[Off, 1, 2]
IFX6
Bus Select
: IFX6
101: Reverb Hall
FX Control Bus: 1
(FX Control Bus1)
[000...127]
[000...127]
Global P5: Drum Kit
Compressor and gate-type effects:
• 002: Stereo Compressor
• 003: Stereo Expander
• 005: Stereo Limiter
• 009: Stereo Gate
• 010: Stereo Noise Reduction
Example: Gated Reverb
This is an example of applying a gated reverb to only a
specific snare sound. When using a gate effect on
reverb, you may not be able to control the gating
timing correctly if you use the extended reverberant
sound to control the gate. Normally, you will control
the gate using sound from before reverb is applied.
For the key for which you've selected the snare sample,
set Bus Select to IFX6. Also use "FX Control Bus
Select" to send the signal to FX Control Bus 1. In IFX7:
Stereo Gate, choose FX Control 1 as the Envelope
Source. Now you can use a signal other than the input
(reverberant sound) to control the gate.
Program P4, P8: Use DKit Setting = On
IFX7
Chain to
: IFX6
009: Stereo Gate
Envelope Source
: FX Control 1
• 2: Swap Key Setup. For more information, see
"Swap Key Setup" on page 689.
5–3: Voice Assign/Mixer
Bus Select
: L/R
679
Advertisement
Table of Contents
