114: Comp - Wah; 115: Comp - Amp Sim - Korg Electronic Keyboard Parameter Manual

Effect Guide

114: Comp - Wah

This effect combines a mono compressor and a wah.
You can change the order of the connection.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Compressor
EQ Trim LEQ HEQ
+
Right
Envelope - Control
Routing
Routing
Switches the order of the compressor and wah.
COMPRESSOR
Pre EQ
Trim
Sets the EQ input level.
Pre LEQ Gain [dB]
Sets the gain of the Low EQ.
Pre HEQ Gain [dB]
Sets the gain of the High EQ
COMPRESSOR
Sensitivity
Sets the sensitivity (see "Sensitivity" on page 764).
Attack
Sets the attack level (see "Attack" on page 764).
Output Level
Sets the compressor output level (see "OUTPUT" on
page 764).

115: Comp - Amp Sim

This effect combines a mono compressor and an amp
simulation. You can change the order of the effects.
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
Left
Compressor
EQ Trim
LEQ HEQ
+
Right
Envelope - Control
858
Routing
Wah/Auto Wah
Comp Wah
Wet / Dry
Output Level
Sweep Mode
Envelope
Auto
D-mod
D -mod
LFO
LFO
[Comp › Wah, Wah › Comp]
[0...100]
[–15...+15]
[–15...+15]
[0...100]
[0...100]
[0...100]
Routing
Amp Simulation
Comp Amp Simulation Filter
Output Level
WAH
CONTROL
Wet / Dry
Sweep Mode
Selects the control from auto-wah, modulation source,
and LFO (see "Sweep Mode" on page 776).
Source
Wet / Dry
Selects the modulation source for the wah when Sweep
Mode=Dmod.
LFO
Frequency [Hz]
Sets the LFO speed.
WAH
Frequency Bottom
Sets the lower limit of the wah center frequency. p.777.
Frequency Top
Sets the upper limit of the wah center frequency. p.777.
Resonance
Sets the resonance amount.
Low Pass Filter
Switches the wah low pass filter on and off.
Wet/Dry
Sets the wah effect balance.
Source
Selects the Wet/Dry modulation source for the wah.
Amount
Sets the Wet/Dry modulation amount for the wah.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Routing
Routing
Switches the order of the compressor and amp
Wet / Dry
simulation.
Wet / Dry
[Auto, Dmod, LFO]
[Off...Tempo]
[0.02...20.00]
[0...100]
[0...100]
[0...100]
[Check-box]
[Dry, 1:99...99:1, Wet]
[Off...Tempo]
[+/–100]
[Comp ➝ Amp, Amp ➝ Comp]