012: Stereo Graphic 7Eq; 013: Stereo Master 3Eq - Korg Electronic Keyboard Parameter Manual

Effect Guide

012: Stereo Graphic 7EQ

This is a stereo 7-band graphic equalizer. The bar
graph of the gain setting for each band gives you a
clear, visual idea of frequency responses. You can select
a center frequency setting for each band from twelve
types, according to the sound.
Stereo In - Stereo Out
Left
Trim
Band1 Band2 Band3 Band4
Trim
Band1 Band2 Band3 Band4 Band5 Band6 Band7
Right
GRAPHIC EQ
Type
4: Half Wide 1, 5: Half Wide 2, 6: Half Wide 3,

013: Stereo Master 3EQ

This is a stereo three-band equalizer. The Low EQ and
High EQ gain can be controlled in real-time.
You can use this as a TFX to make final adjustments to
the sound.
Stereo In - Stereo Out
Left
Trim
Trim
Right
D -mod
D -mod
PARAMETRIC EQ
Trim
Sets the input level.
Low Fc [Hz]
Sets the cutoff frequency of the Low EQ (shelving
type).
Gain [dB]
Sets the gain of the Low EQ.
Mid Cutoff [Hz]
Sets the cutoff frequency of the Mid EQ (peaking type).
Q
Sets the bandwidth of the Mid EQ
Gain [dB]
Sets the gain of the Mid EQ.
774
Band5 Band6 Band7
[1:Wide 1, 2:Wide 2, 3:Wide 3,
Low Mid High
LEQ PEQ HEQ
[0...100]
[0...980]
[–18.0...+18.0]
[100...10.00k]
[0.5...10.0]
[–18.0...+18.0]
7:Low, 8:Wide Low, 9:Mid, 10: Wide Mid,
This parameter selects a combination of center
frequencies for each band. Each center frequency is
shown on the bottom of the Gain slider.
You can configure a 21-Band Graphic EQ ranging from
80Hz to 18kHz if you route three Graphic 7Band EQ
Wet / Dry
effects in series, with a setting of 7:Low, 9:Mid, and
11:High for each EQ.
Trim
Sets the input level
Wet / Dry
(Band1...8 Gain [dB])
These controls set the gain for each of the eight bands.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
High Cutoff [Hz]
Sets the cutoff frequency of the High EQ (shelving
type).
Gain [dB]
Sets the gain of the High EQ.
Wet / Dry
GAIN MOD
Low Source
Selects the source that will modulate the Low Gain.
Wet / Dry
Amount [dB]
Sets the amount by which the Low Gain will be
modulated.
High Source
Selects the source that will modulate the High Gain.
Amount [dB]
Sets the amount by which the High Gain will be
modulated.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
11:High, 12:Wide High]
[0...100]
[–18.0...+18.0]
[500...20.00k]
[–18.0...+18.0]
[Off...Tempo]
[–36.5...+36.0]
[Off...Tempo]
[–36.5...+36.0]