097: St. Bpm Auto Panning Dly - Korg Electronic Keyboard Parameter Manual

Effect Guide
Times
Sets the number of notes to specify the right channel
delay time. p.822.
L Depth
Sets the depth of the left LFO modulation.
R Depth
Sets the depth of the right LFO modulation.

097: St. BPM Auto Panning Dly

This stereo auto panning delay enables you to set the
delay time to match the song tempo.
Stereo In - Stereo Out
Left
Delay
Delay
Right
Tempo
BPM
Base Note x Times
BPM
Base Note x Times
LFO: Tri / Sin LFO Shape
DELAY
BPM
MIDI syncs to the system tempo; 40-240 sets the tempo
manually for this individual effect. p.822.
Time Over? L >
Time Over? R >
The maximum delay time is 1,360msec per channel
(left and right). If the channel's combination of BPM,
Base Note, and Times exceeds this limit, the error
message "OVER!" will appear. If this occurs, change
the delay time parameters so that this message no
longer appears.
L Delay Note
Selects the type of notes to specify the left channel
delay time. p.822
Times
Sets the number of notes to specify the left channel
delay time. p.822.
R Delay Note
Selects the type of notes to specify the right channel
delay time. p.822.
Times
Sets the number of notes to specify the right channel
delay time. p.822.
L Feedback
Sets the feedback amount for the left channel.
846
[x1...x32]
[0...200]
[0...200]
High Damp Low Damp
Pan
Depth
Feedback
Pan
High Damp Low Damp
LFO Phase
[MIDI, 40.00...240.00]
[---, OVER!]
[---, OVER!]
[x1...x32]
[x1...x32]
[+/–100]
L Feedback
Sets the feedback amount of left delay.
R Feedback
Sets the feedback amount of right delay.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
R Feedback
Sets the feedback amount for the right channel.
High Damp [%]
Wet / Dry
Sets the damping amount in the high range. p.829.
Low Damp [%]
Sets the damping amount in the low range. p.829.
LFO
Wet / Dry
Waveform
Selects the LFO Waveform.
Shape
Changes the curvature of the LFO Waveform. p.780.
Phase [degrees]
Sets the LFO phase difference between the left and
right. p.814.
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
MIDI/Tempo Sync
BPM
Base Note
[ ... ] Times
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on
page 777.
Type
This controls whether the effect uses its individual
[ ... ]
LFO, or one of the Common FX LFOs. For more
information, see "LFO Type" on page 777.
Common LFO Phase Offset [degrees]
When Type is set to Common FX LFO 1 or 2, this lets
you offset the phase from the master LFO.
AUTO PAN
Depth
Sets the panning width.
[Triangle, Sine]
[–180...+180]
[0.02...20.00]
[Check-box]
[MIDI, 40.00...240.00]
[Individual, Common1, Common2]
[+/–100]
[+/–100]
[+/–100]
[0...100]
[0...100]
[+/–100]
[ ... ]
[x1...x32]
[+/–180]
[0...100]