Ms-20Ex Tone Adjust - Korg Electronic Keyboard Parameter Manual

MS-20EX Tone Adjust

MS-20EX Tone Adjust Default Settings
VCO1 VCO1 VCO2 VCO2
Waveform Waveform Waveform Waveform
EG1 EG1 EG1 EG1
Delay Delay Attack Attack
Tone Adjust provides an elegant physical interface to
the MS-20EX's parameters. Most of the factory sounds
use the default layout, as shown above. You can also
customize the layout for individual sounds, if desired.
For more information about Tone Adjust, please see
"0–9f: Tone Adjust," on page 26.
Common Tone Adjust parameters
These parameters affect both EXi 1 and 2. Except as
noted below, the Common Tone Adjust parameters
behave as described under "Common Tone Adjust
Parameters," on page 28.
Filter Cutoff. (–99...+99, CC#74)
This scales the cutoff frequency of the lowpass filter. To
adjust the highpass filter, use the separate, MS-20EX-
specific Tone Adjust parameters.
Filter Resonance. (–99...+99, CC#71)
This scales the resonance (PEAK) of the lowpass filter.
To adjust the highpass filter, use the separate, MS-
20EX-specific Tone Adjust parameters.
Filter EG Intensity. (–99...+99, CC#79)
This scales the EG2/EXT knob for the lowpass filter.
Amp Velocity Intensity. (–99...+99)
Not supported.
Filter/Amp EG Attack Time.
(–99...+99, CC#73)
This scales the attack time of EG2, which is normalled
to both filter cutoff and amplitude.
MS-20EX Tone Adjust
HPF HPF HPF HPF HPF HPF
Cutoff Cutoff Peak Peak EG2/Ext Mod EG2/Ext Mod
EG1 EG1 EG2 EG2 EG2 EG2
Release Release Attack Attack Decay Decay
Common Tone Adjust parameters
LPF LPF LPF LPF
Cutoff Cutoff Peak Peak EG2/Ext Mod EG2/Ext Mod
EG2 EG2 EG2 EG2 MG MG
Sustain Sustain Release Release Waveform Waveform
Filter/Amp EG Decay Time.
(–99...+99, CC#75)
This scales the decay time of EG2. It interacts with CC#
75.
Filter/Amp EG Sustain Level.
(–99...+99, CC#70)
This scales the sustain level of EG2.
Filter/Amp EG Release Time.
(–99...+99, CC#72)
This scales the release time of EG2.
Filter EG, Amp EG, and Pitch EG Attack Time, Decay
Time, Sustain Level, Release Time are not supported
by the MS-20EX.
Pitch LFO1 Intensity. (–99...+99, CC#77)
This scales the FREQUENCY MODULATION
MG/T.EXT knob. (Note that this controls the amount
of pitch modulation, but does not necessarily apply to
LFO1.)
MS-20EX Tone Adjust parameters
In addition to the Common Tone Adjust parameters
listed above, the MS-20EX adds a number of its own
parameters.
Note that these additional parameters are separate for
each EXi, as opposed to being shared by both EXi in
the Program.
LPF LPF
Switches 7, 8, 15, 16: Switches 7, 8, 15, 16:
LFOs 1, 2, 3, 4 Stop LFOs 1, 2, 3, 4 Stop
MG MG
Frequency Frequency
305