Table of Contents
Advertisement
8–6: Track View
1–1a
8–6a
8–6b
8–6a: Track View
This shows the oscillator 1, 2 output and insert effect
routing.
The selected slot is shown in dark blue. In the
"Selected" area below, you can specify the "Effect
Type" and "On/Off" status. The "Insert IFX Slot" and
"Cut IFX Slot" page menu commands will apply to the
slot you select here.
If you move from this page to the P8– IFX1–12 page,
the IFX you choose here will be selected.
In the following diagram, the "Audio In" shown below
IFX10 and IFX11 indicates the insert effects through
which Audio Input 1–4 and S/P DIF L/R are passing.
In this example, you can see that Audio Input 1–4 and
S/P DIF L/R are passing through IFX11 and IFX12.
"OUTPUT" shows the Bus Select setting that follows
the insert effects. This tells you where the audio signal
is being output.
8–6b: Selected
Here you can specify the "Effect Type" and "On/Off"
status of the insert effect slot selected by Track Select.
("8–6a: Track View," above)
Program P8: Insert Effect
8–5b
The following diagram shows the IFX assigned to each
key of a drum kit when Oscillator Mode is set to
Drums for an HD-1 Program and Use DKit Setting is
turned on.
In this example, you can see that IFX1, 2, 3, 4, and 5 are
each used by a key in the drum kit (shown in light
blue). If you press an IFX that is being used, that effect
will be shown in the line below.
▼ 8–6: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
8–6: Track View
8–6PMC
129
Advertisement
Table of Contents
