Table of Contents
Advertisement
Effect Guide
Fig. 2–2a
In the diagram (Fig. 2–2b), IFX1's Chain check box is
checked and Chain to set to IFX2, sending the output
of IFX1 to IFX2. Timbre 1 is being processed by IFX1:
001: Stereo Dyna Compressor and IFX2: 048: Stereo
Fig. 2–2b
Drum Programs in Combination and
Sequencer modes
If a drum program (Oscillator Mode = Drums) is
selected for a timbre (Combination) or track
(Sequencer), the DKit check box is available (Fig. 2–2c).
Checking this check box will enable the Bus Select
settings etc. of each key in the drum kit, letting you
specify the bus to which each drum instrument will be
738
Flanger effects. Timbre 2 is being processed by the
IFX2: 048: Stereo Flanger effect. The Routing Map area
of the diagram (Fig. 2–1a) shows these settings. (With
these settings, IFX3–12 are not being used.)
sent. For example you can send snare sounds to IFX1,
kick sounds to IFX2, and other drum sounds to
L/MONO and R.
If this check box is unchecked, all drum instruments
will be output according to the Bus Select setting of
each timbre/track (the P8 - Routing page of each
mode). This lets you apply an insert effect to all of the
drum instruments in that drum kit.
Advertisement
Table of Contents
