1-2: Play Audio Cd - Korg Electronic Keyboard Parameter Manual

Disk mode
1–2: Play Audio CD
1–2a
Here you can use the internal CD-R/RW drive or a
USB-connected CD-R/RW drive to play an audio CD.
It is convenient to use this method to verify a CD that
you created in the Make Audio CD page.
It is not possible to play back an audio CD that has
not been finalized.
You can use the SEQUENCER switches to play or stop
the internal CD-R/RW drive or a USB-connected CD-
R/RW drive. The digital audio signal from the audio
CD will be input.
To play back an audio CD, use "Drive Select" to select
the drive, and use CD-R/RW Drive Audio Input to set
the "Level," "Bus (IFX/Indiv)," Pan, and "Level." and
Bus Select (IFX/Indiv.) for the LEFT (L channel) and
RIGHT (R channel).
The audio CD can be controlled by the SEQUENCER
switches.
SEQUENCER
START/STOP switch
FF>> switch
<<REW switch
PAUSE switch
LOCATE switch
If you play the keyboard or controllers while the
internal CD-R/RW drive is playing, the impact may
cause skips or read errors to occur in the playback.
700
Play/Stop
Fast-forward
Rewind
Pause
Return to the beginning of the track
1–2b
1–2a: Audio CD Play
Location
Displays the current location of the audio CD track
that is playing. When stopped, this specifies the
location at which playback will begin.
When Track or Index are re-selected, this will be
00:00.0.
Drive Select
Specifies the drive of the audio CD that will be played.
Only CD-ROM/R/RW drives can be selected.
Track
Selects the audio CD track that will be played.
Index
Specifies the index of the audio CD that will be played.
This is valid only if you have selected a track that has
index data.
In the case of some CD-R/RW drives, index
information cannot be obtained.
Volume
Specifies the volume of the audio output from the CD-
R/RW drive.
Since some CD-R/RW drives do not support this, the
volume may not change when you adjust this setting.
1–2b: CD-R/RW Drive Audio Input
This specifies the output destination for the signal from
an audio CD played back on the internal CD-R/RW
drive or a USB-connected CD-R/RW drive. Make
settings for the L and R channels.
1–2PMC
[(00:00.0...)]
[01...]
[01...]
[000...127]