Table of Contents
Advertisement
Sequencer mode
Knobs 1–8
Knobs 1–4 all have dedicated functions which
correspond to MIDI CCs. Knobs 5–8 can be assigned to
a wide variety of functions, many of which also have
corresponding MIDI CCs.
When you move the knob, it will send the
corresponding MIDI CC to the current Keyboard
Track, and also to all Tracks on the same MIDI Channel
as the Keyboard Track. (To edit individual Programs,
use Tone Adjust instead.)
Also, when the CC is received via MIDI or generated
by KARMA, the knob value will change to match the
CC value.
Note that the Knob 1–8 settings of the individual
Programs do not apply in Sequencer mode.
Unless otherwise noted, "scaling" means that the
parameters are at their programmed values when the
controller is at 64, at their minimum when the
controller is at 0, and at their maximum when the
controller is at 127. For another look at this, see the
diagram below.
CC scaling of parameters
99
Parameter
Value
As Programmed
00
0
Knob 1: CUTOFF (CC#74)
This knob scales the cutoff frequencies of Filters A and
B, and transmits and receives MIDI CC #74.
Knob 2: RESONANCE (CC#71)
This knob scales the resonance of Filters A and B, and
transmits and receives MIDI CC #71.
Knob 3: Filter EG Intensity (CC#79)
This knob scales the effect of the Filter EG on the cutoff
frequencies of Filters A and B. It also transmits and
receives MIDI CC#79.
Knob 4: EG Release (CC#72)
This knob scales the release time of the Filter and Amp
EGs, and transmits and receives MIDI CC#72.
Knobs 5–8
You can set knobs 5–8 to a wide variety of modulation
functions, using the Controller Setup page (P1–8).
Many of the functions scale a particular set of Program
parameters. All of the settings also correspond to MIDI
messages–usually CCs.
446
64
127
CC Value
[000...127]
[000...127]
[000...127]
[000...127]
[000...127]
KARMA SCENES 1-8
A KARMA Scene includes the settings for all of the
KARMA Sliders and Switches. Each Song can contain
up to eight Scenes.
To select a Scene, just press its switch - you'll see all of
the KARMA Sliders and Switches update instantly to
their new values.
KARMA SWITCHES 1-8
These switches control KARMA Performance or GE
(Generated Effect) Real-Time Parameters, as assigned
on the KARMA Perf RTP and GE RTP pages.
Karma Sliders 1-8
These sliders control KARMA Performance or GE
Real-Time Parameters, as assigned on the KARMA
Perf RTP and GE RTP pages.
Master Volume Slider
Master Volume
This controls the volume of the main stereo outputs,
after the Total Effects. It does not affect Individual
Outputs 1–8. For more information, see the diagram
"Master Volume" on page 441.
[000...127]
Advertisement
Table of Contents
