112: P4Eq - Phaser - Korg Electronic Keyboard Parameter Manual

Effect Guide
CHORUS/FLANGER
LFO
Waveform
Selects the LFO Waveform.
Frequency [Hz]
Sets the LFO speed.
FLANGER
Delay Time [msec]
Sets the delay time.
Depth
Sets the depth of LFO modulation.
Feedback
Sets the feedback amount. p.803.
Output Mode
Normal sends the output of the chorus/flanger to both
outputs with the same phase.

112: P4EQ - Phaser

This effect combines a mono four-band parametric
equalizer and a phaser.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
Parametric 4Band EQ
+
Trim
Right
PARAMETRIC EQ
Trim
Sets the parametric EQ input level.
Band1 Fc [Hz]
Sets the center frequency of Band 1.
Q
Sets the bandwidth of Band 1. p.773.
Gain [dB]
Sets the gain of Band 1.
Band2 Fc [Hz]
Sets the center frequency of Band 2.
Q
Sets the bandwidth of Band 2. p.773.
Gain [dB]
Sets the gain of Band 2.
856
[Triangle, Sine]
[0.02...20.00]
[0.0...1350.0]
[0...100]
[+/–100]
[Normal, Wet Invert]
Wet / Dry
Phaser
Phaser
Normal
+
Output Mode
—
Wet Invert
Resonance
Phaser Wet / Dry
Wet / Dry
LFO: Tri / Sine
[0...100]
[20...1.00k]
[0.5...10.0]
[–18...+18]
[50...5.00k]
[0.5...10.0]
[–18...+18]
Wet Invert flips the phase of the chorus/flanger's right
channel. This creates a pseudo-stereo effect, adding
depth to the sound.
However, if a mono-input type effect is connected after
this effect, the left and right sounds may cancel each
other, eliminating the chorus/flanger effect.
Wet/Dry
Sets the effect balance of the chorus/flanger. p.780,
p.804.
Source
Selects the Wet/Dry modulation source for the
chorus/flanger.
Amount
Sets the Wet/Dry modulation amount for the
chorus/flanger.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Band3 Fc [Hz]
Sets the center frequency of Band 3.
Q
Sets the bandwidth of Band 3. p.773.
Gain [dB]
Sets the gain of Band 3.
Band4 Fc [Hz]
Sets the center frequency of Band 4.
Q
Sets the bandwidth of Band 4. p.773.
Gain [dB]
Sets the gain of Band 4.
PHASER
LFO
Waveform
Selects the LFO Waveform.
Frequency [Hz]
Sets the LFO speed.
PHASER
Manual
Sets the phaser's center frequency.
Depth
Sets the depth of LFO modulation.
[Dry, 1:99...99:1, Wet]
[Off...Tempo]
[+/–100]
[300...10.00k]
[0.5...10.0]
[–18...+18]
[500...20.00k]
[0.5...10.0]
[–18...+18]
[Triangle, Sine]
[0.02...20.00]
[0...100]
[0...100]