System Exclusive Events Supported In Sequencer Mode - Korg Electronic Keyboard Parameter Manual

Sequencer mode

System Exclusive events supported in Sequencer mode

You can record and play back System Exclusive events,
and edit tracks that contain System Exclusive events.
SysEx messages that can be recorded in real-time
The following exclusive messages can be recorded in
real-time:
Parameter change messages that you can realtime-record in Sequencer mode
Front panel/Page
KARMA
Front panel
Control Surface
MIDI Prog Mixer
Audio Track Mixer
P0: Play/REC
Audio In Sampling
Control Surface
MIDI Track EQ
Audio Track EQ
Vector Volume
P1: EQ/Vector
Control
Vector CC
Vector Envelope
Set Up Controllers
Set Up Pads
MIDI
OSC
Pitch
P2: Track Param
Delay
WaveSeq KARMA
Audio Track Delay
GE Setup Key Zones
P7: KARMA
Name Note Map
MIDI/Audio Routing1/2 "Bus Select, Send1, Send2, Fx Control Bus, Rec Bus
Insert FX
P8: IFX
IFX 1-12
Common FX LFO
Routing
P9: MFX/TFX
MFX 1/2
TFX 1/2
*1:Solo On/Off is always controlled by events in the
track, regardless of the play/mute status of that
track.
The maximum amount of exclusive data that can be
recorded at once is approximately 320 Kbytes. This
size will decrease if other events exist within the
same measure.
560
• Exclusive messages received from an external MIDI
device
• Parameter changes in Sequencer mode (see table
below)
• Master Volume universal exclusive messages
assigned to the foot pedal or a knob
ON/OFF, LATCH, MODULE CONTROL switches
CONTROL ASSIGN, MIXER KNOBS, PAD MODE switches
Program Select, Pan, Volume, PLAY/MUTE, Solo On/Off
Rec Source, Pan, Volume, PLAY/MUTE, Solo On/Off
All "Audio Input" parameters
All "RT/KARMA" – "REAL TIME CONTROL," "KARMA SCENE," "KARMA SWITCH,"
"KARMA SLIDER" parameters, "TONE ADJ." – Assign, Value
Auto Load Prog EQ, Bypass, Input Trim, High Gain, Mid Frequency, Mid Gain, Low
Gain
Bypass, Input Trim, High Gain, Mid Frequency, Mid Gain, Low Gain
All "Vector Volume Control" parameters, VJS Assign, Center Volume, Enable Program
Vector Volume
All "Vector CC Control" parameters, Enable Song Vector CC, Enable Program Vector
CC
All "Basic," "Vector Envelope Loop," "Vector Envelope" parameters
All "Panel Switch Assign," "Modulation Knob Assign" parameters
All "Pads Chord" parameters
Track Priority
Force OSC Mode, OSC Select, Portamento
Transpose, Detune, Bend Range, Use Program's Scale, Type, Key, Random
Mode, Time, Base Note, Times
Key Sync, Swing, Quantize Trigger, KARMA Track On/Off Control
Mode, Time, Base Note, Times
Load GE Options
All parameters except "Octave Replicate"
IFX, IFX On/Off, Chain to, Chain, Pan, Bus Sel, REC Bus, Ctrl Bus, Send1, Send2
All effect parameters
All "Common FX LFO 1, 2" parameters
MFX, MFX On/Off, Chain, Chain Direction, Chain Level, Return 1, Return 2, TFX, TFX
On/Off, Master Volume
All effect parameters
All effect parameters
You cannot simultaneously record exclusive
messages received from an external MIDI device
and parameter changes produced by editing.
If you record a parameter assigned to a control
change such as Pan with the Global mode Global
P1: MIDI, MIDI Filter settings "Enable Control
Change" and "Enable Exclusive" both checked,
edits you make during recording will be recorded
both as control change data and parameter change
Parameter
*1
*1