Table of Contents
Advertisement
Global mode
Off (unchecked): System exclusive data will not be
transmitted. Normally you will leave this unchecked.
However, system exclusive data will be transmitted
and received while the page menu commands ("Dump
Program"–"Dump All") of this page are displayed.
▼ 1–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Global Setting. For more information, see
"Write Global Setting" on page 682.
• 1: Dump Program. For more information, see
"Dump Program" on page 685.
1–2: External 1
1–2a
1–2b
This page lets you set up the knobs, sliders, and
switches for the Control Surface's EXTERNAL mode.
In this mode, each slider, knob, and switch can be
assigned to a separate MIDI controller and MIDI
channel.
The eight drum pads also have separate settings which
apply only when Control Assign is set to External; for
more information, see "1–3: External 2" on page 658.
You can create up to 128 different External Setups. For
instance, you might make one setup for controlling
several different pieces of MIDI gear on stage, another
for controlling a software synthesizer (such as one of
Korg's Legacy Collection synths), and so on.
These External Setups are completely separate from
the Program. You can think of External mode as being
a separate control surface which just happens to share
OASYS's sliders, knobs, switches, and drum pads.
656
• 2: Dump Combination. For more information, see
"Dump Combination" on page 685.
• 3: Dump Drum Kit. For more information, see
"Dump Drum Kit" on page 685.
• 4: Dump Wave Sequence. For more information,
see "Dump Wave Sequence" on page 685.
• 5: Dump Global Setting. For more information, see
"Dump Global Setting" on page 685.
• 6: Dump Sequencer. For more information, see
"Dump Sequencer" on page 685.
• 7: Setup KARMA External MIDI Routing. For
more information, see "Set Up KARMA External
MIDI Routing" on page 686.
• 8: Reset External Setup. For more information, see
"Reset External Setup" on page 687.
When you select an External Setup, it stays selected
even when you change Programs, or switch to Combi
or Sequencer modes. This makes it easy to select
different OASYS sounds without disrupting any
external MIDI control, and vice-versa.
Note: After editing the setups, make sure to save your
edits using the page menu's Write Global command.
You can also call up this menu command by holding
ENTER and pressing 0 on the numeric keypad.
1–2a: External Mode Setup
Setup
This selects the Global setup to edit.
1–2PMC
[000...127]
Advertisement
Table of Contents
