Korg Electronic Keyboard Parameter Manual page 359

Vector Synthesis system, Combi mode
Combination
Combi
+
Vector EG
Vector Joystick
MIDI In
(Global Chan.)
Vector Joystick
Timbre 1
The front-panel Vector Joystick applies only
when the Timbre is set to the Global Channel
Vector Joystick
MIDI In
(Timbre Chan.)
Program
+
Vector EG
1–5b: Vector Volume Control
Vector Volume Control lets you adjust the relative
volumes of the 16 Timbres by moving the Vector
Joystick (or the Vector Envelope) from left to right on
the X axis, and up and down on the Y axis.
The Equal Amount check-box makes the Vector create
a smooth fade between the Timbres, while the
individual Timbre Center Volume parameters allow
you to create more complex fade shapes.
Combination P1: EQ/Vector/Controller
Combi Vector Volume Control
Timbres 1-16 Center Volume
and Equal Power settings
Combi Vector CC Control
VJS X and Y modes
CC Assignments
Vector CC MIDI Output
Global Controllers
MIDI CC Assignments
Defaults: X=118, Y=119
Program Vector Volume Control
Osc 1-2 Center Volume
and Equal Power settings
Program Vector CC Control
X+/- and Y+/-
VJS X and Y modes
CC Assignments
Combi switch:
Enable Volume control
Combi switch:
Enable CC control
X+/- and Y+/-
Global switch:
Vector MIDI Out
Vector CC Control
Vector Joystick
Program switch:
Enable Volume control
Program switch:
Enable CC control
Enable Volume Control
When this box is checked, the Vector position will
control the volumes of all Timbres whose VJS Assign
parameter is not set to Off.
When this box is not checked, the Vector position will
not directly affect volume. However, it's still possible
for the Vector to control volume via Vector CCs and
AMS, depending on the individual Program's
parameter settings.
1–5: Vector Volume Control
Vector Modulation of
Timbre Volume
Vector CC Modulation of
Program and FX Parameters
(Global Channel Only)
Vector CC MIDI Output
Vector Modulation of
Osc 1-2 Volume
Vector CC Modulation of
Program Parameters
Timbre 16
[Off, On]
349