Table of Contents
Advertisement
8–9: Common FX LFO
8–9a
8–9b
The two Common FX LFOs allow you to synchronize
LFO-based modulation for multiple effects, such as
phasers, flangers, filters, and so on.
The Common LFOs control only the frequency, MIDI
synchronization, and reset options; each individual
effect still has its own settings for the LFO waveform
and phase.
Within the individual effects, you can choose whether
to use one of the Common LFOs, or to use the
individual effect's frequency, sync, and/or reset
settings instead. This is done via the effect's LFO Type
parameter; select Individual to use the effect's settings,
or Common 1 or 2 to use the Common LFOs.
8–9a: Common FX LFO1
Ch (Control Channel)
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for Common LFO 1 and 2.
G ch: The global MIDI channel will be used for
control. This is the default.
Combination P8: Insert Effect
[Ch01...Ch16, G ch]
Sync (Reset)
Source (Dmod Source)
Frequency
MIDI/Tempo Sync
BPM
[ , 3 ,
Base Note
Times
These parameters are the same as in Program mode.
For details, see "8–9a: Common FX LFO1" on page 132.
8–9b: Common FX LFO2
These parameters are the same as for Common FX
LFO1. For more information, please see "8–9a:
Common FX LFO1" on page 132.
▼ 8–9: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Combination. For more information, see
"Write Combination" on page 405.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
• 2: Copy Insert Effect. For more information, see
"Copy Insert Effect" on page 149.
• 3: Swap Insert Effect. For more information, see
"Swap Insert Effect" on page 150.
8–9: Common FX LFO
8–9PMC
[Off, On]
[List of Dmod Sources]
[0.02...20.00 Hz]
[Off, On]
[MIDI, 040.00...240.00]
, 3 ,
, 3 , , 3 , , ]
[01...32]
401
Advertisement
Table of Contents
