090: Sequence Bpm Delay - Korg Electronic Keyboard Parameter Manual

Effect Guide
Reverse Time [msec]
This specifies the maximum time of the reverse
playback. For short, single-note slapback effects, set
the Reverse Time to a low value.
Direct Mix [Always On, Always Off, Cross Fade]
Selects how the dry sound is mixed. For more
information, see "PLAYBACK: Direct Mix" on
page 813.

090: Sequence BPM Delay

This four-tap delay enables you to select a tempo and
rhythm pattern to set up each tap.
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Left
Input Level D-mod
+
High Damp Low Damp
Input Level D-mod
Right
Tempo
BPM
Rythm Pattern
INPUT
Input Level Dmod [%]
Sets the modulation amount of the input level. p.820.
Source
Selects the modulation source for the input level. p.820.
DELAY
BPM
MIDI syncs to the system tempo; 40-240 sets the tempo
manually for this individual effect. p.840.
Rhythm Pattern
Selects a rhythm pattern. p.840.
Tap1 Pan
Sets the panning of Tap1.
Tap2 Pan
Sets the panning of Tap2.
Tap3 Pan
Sets the panning of Tap3.
Tap4 Pan
Sets the panning of Tap4.
Feedback
Sets the feedback amount
Source
Selects the modulation source of feedback amount.
840
[20...2640]
Pan
Delay
Feedback
BPM
[+/–100]
[Off...Tempo]
[MIDI, 40.00...240.00]
[ ...
[L, 1...99, R]
[L, 1...99, R]
[L, 1...99, R]
[L, 1...99, R]
[+/–100]
[Off...Tempo]
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Amount
Sets the feedback amount.
High Damp [%]
Wet / Dry
Sets the damping amount in the high range. p.829.
Low Damp [%]
Sets the damping amount in the low range. p.829.
OUTPUT
Wet / Dry
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
DELAY: BPM and Rhythm Pattern
With the tempo specified by the BPM parameter (or
the MIDI Clock tempo if BPM is set to MIDI), the
length of one beat equals the feedback delay time, and
the interval between taps becomes equal. Selecting a
rhythm pattern will automatically turn the tap outputs
on and off. When BPM is set to MIDI, the lower limit of
the BPM is 44.
3]
[+/–100]
[0...100]
[0...100]