7-2: Midi Filter/Cc Offset - Korg Electronic Keyboard Parameter Manual

7–2: MIDI Filter/CC Offset
1–1a
7–2a
7–2b
7–2a: MIDI Filter
Receive MIDI Filter
For each KARMA Module, specify whether to filter the
MIDI control data received by the Module.
After Touch
Pitch Bend
Damper (CC#64)
JS+Y (CC#01)
JS–Y (CC#02)
Ribbon (CC#16)
Other CC
Please see "Receive MIDI Filter" on page 100.
Transmit MIDI Filter
For each KARMA Module, specify whether to filter the
MIDI control data generated by the GE selected for the
Module.
Pitch Bend
Please see "Transmit MIDI Filter" on page 101.
If the KARMA function is on and a KARMA
Module is generating pitch bend data, the Bend
Range ("2–3a: Pitch" on page 363) of the timbre will
be controlled as follows.
The pitch bend range specified within the KARMA
GE will be transmitted from the KARMA Module so
that the corresponding timbre will be forcibly set to
Combination P7: KARMA
this bend range. This ensures that the pitch bend
data generated by the KARMA Module's GE will
function as intended. At this time, pitch bender data
produced by operating the joystick will
automatically be adjusted to produce the same bend
effect as when KARMA is off (in most cases). If
multiple timbres are being controlled by one
[Off, On]
KARMA Module, the settings of the lowest-
numbered timbre will be used.
[Off, On]
CC–A, CC–B
[Off, On]
Envelope1, Envelope2, Envelope3
[Off, On]
GE Notes
[Off, On]
WaveSeq
[Off, On]
For more information, see "Transmit MIDI Filter" on
[Off, On]
page 101.
7–2b: CC Offset
When the KARMA function is turned on, MIDI control
change messages are transmitted to the tone generator.
This lets you use MIDI control change messages to
control program sounds or effects when the KARMA
function is on.
[Off, On]
These messages will be transmitted on the "Output
Channel" (7–1c) of the KARMA Module.
For more information, see, "7–2c: CC Offset" on
page 102.
7–2: MIDI Filter/CC Offset
7–2PMC
[Off, On]
[Off, On]
[Off, On]
[Off, On]
379