Table of Contents
Advertisement
Program mode: HD-1
Note f: If you execute Auto Sampling Setup with "Save
to" RAM and the "Convert to Program" option
checked, and you continue sampling, each successive
sample will be automatically assigned to C2, C#2, D2,
... to create a multisample. A new multisample will be
created the next time you execute Auto Sampling
Setup and start sampling.
REC Audio Input
If you selected REC Audio Input:
1. Use "Source Audio" to select the external audio
input source.
Analog1/2: Selects the analog audio source connected
to the AUDIO INPUT 1 and AUDIO INPUT 2 jacks.
Analog3/4: Selects the analog audio source connected
to the AUDIO INPUT 3 and AUDIO INPUT 4 jacks.
S/P DIF: Selects the digital audio source connected to
the S/P DIF jack.
2. Use "Mono-L/Mono-R/Stereo" to specify whether
the input source is mono or stereo.
Mono-L: Settings will be made for sampling to L-
MONO from Input 1 (if you've selected Analog 1/2) or
from Input 3 (if you've selected Analog 3/4).
Mono-R: Settings will be made for sampling to R-
MONO from Input 2 (if you've selected Analog 1/2) or
from Input 4 (if you've selected Analog 3/4).
Stereo: Settings will be made for sampling Input 1/2
or 3/4 in stereo.
3. Use "Save to" to specify the writing-destination
for the sampled data. RAM will write the data into
RAM memory. DISK will create a WAVE file of the
sampled data, and save it to disk.
4. If you've selected "Save to" RAM, you can specify
whether the sample will automatically be
converted to a program. If you want the sample to
be converted to a program, check "Convert to
Program" and use the "Program" field to specify
the convert-destination program.
5) If you want to apply an insert effect to the
external audio input source while you sample, use
"IFX" to select the insert effect you want to use.
Turn this off if you don't want to use an insert effect.
6) Press the OK button to execute REC Audio Input.
If you decide not to execute, press the Cancel
button. (See "Automatically-set parameters and
their values" on page 143)
142
Note: To sample, execute REC Audio Input, then press
SAMPLING REC, and then START/STOP to begin
sampling. (This is because "Trigger" is set to Sampling
START SW.) When you're finished, press the
SAMPLING START/STOP switch to stop sampling.
If you want to sample while monitoring the
performance generated by the KARMA function, check
"Latch" and start sampling while the KARMA
function is playing.
Note: If you've set "Source Audio" to S/P DIF, use
System Clock (Global 0–2a) to change the system
clock.
Note: If you want to apply an insert effect to the input
source while you sample, make the following settings.
In the Program P0– Sampling page Input 1–4, S/P DIF
L/R, use "Bus (IFX/Indiv.) Select" to choose IFX1–
IFX12, choose 1/2 as the REC Bus following the insert
effect you're using, and set Source Bus to REC1/2.
For additional information, refer to Note b)–f) in "If
you selected Resample Program Play."
Advertisement
Table of Contents
