Dynamics; 000: No Effect; 001: Stereo Dyna Compressor - Korg Electronic Keyboard Parameter Manual

Effect Guide

Dynamics

000: No Effect

Choose this option when you are not using the selected
effects slot. This frees up processing resources for other
effects and/or synth voices.

001: Stereo Dyna Compressor

This effect compresses the input signal to regulate the
level and give a "punchy" effect. It is useful for guitar,
piano, and drum sounds. This is a true stereo effect;
you can link the left and right channels, or use each
channel separately.
Stereo In - Stereo Out
Left
EQ Trim
Envelope Select
EQ Trim
Right
ENVELOPE
Select
This determines how the left and right channels of the
selected Source are used for controlling the
compressor. Note that this applies only to the control
signal; the effect always processes both channels of the
input signal in stereo.
L/R Mix is generally the best choice for stereo signals;
this compresses both channels equally, based on the
combined volumes of the left and right channels.
L/R Individually splits the effect into two separately
controlled mono compressors. When processing stereo
signals, this will cause the stereo image to shift.
Pre EQ
Trim
This sets the input level for the EQ.
LEQ Fc
Selects the frequency of the EQ's low band.
LEQ Gain [dB]
Sets the gain of the Low EQ.
HEQ Fc
Selects the frequency of the EQ's high band.
HEQ Gain [dB]
Sets the gain of the High EQ.
764
LEQ HEQ
Compressor
Output Level
Envelope - Control
Envelope - Control
Output Level
Compressor
LEQ
HEQ
[L/R Mix, L/R Individually]
[0...100]
[Low, Mid-Low]
[–15.0...+15.0]
[High, Mid-High]
[–15.0...+15.0]
When a slot is set to No Effect:
• Insert Effects and Total Effects pass through the
dry, unprocessed signal
• Master Effects mute their outputs
COMPRESSOR
Sensitivity
This controls the amount of compression. Increasing
the value boosts lower level sounds, and raises the
overall volume.
To adjust the final volume, use the Output Level
Wet / Dry
parameter.
Level
Wet / Dry
Attack
This controls the onset time of the compressor.
Level
Attack=80
Attack=20
Dry
Output Level
Sets the output level of the compressor.
Source
Selects the modulation source for the Output Level.
Amount
Sets the modulation amount for the Output Level.
OUTPUT
Wet/Dry
Sets the balance between the "wet" processed sound
and the dry input.
Source
Selects a modulation source for Wet/Dry.
Amount
Sets the modulation amount for Wet/Dry.
Dyna Compressor - Sensitivity
Wet
Sensitivity=100
Sensitivity=40
Dry
Time
Dyna Compressor - Attack
Wet
Time
[Dry, 1:99...99:1, Wet]
[1...100]
[1...100]
[0...100]
[Off...Tempo]
[+/–100]
[Off...Tempo]
[+/–100]