Table of Contents
Advertisement
On Value
The parameter is set to this value when the switch is
On.
When the switch is assigned to a two-state Absolute
parameter, such as Hold, this will always be the same
as the Switch Status (see below).
Switch Status
This simply shows whether the switch is On or Off.
The status is also shown by the LEDs in the physical
buttons.
Sliders 1–8 and Master Slider
These work identically to Knobs 1–8, as described
above.
▼ 0–9: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Memory Status. For more information, see
"Memory Status" on page 524.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
• 2: Rename Song. For more information, see
"Rename Song" on page 524.
• 3: Delete Song. For more information, see "Delete
Song" on page 524.
• 4: Copy From Song. For more information, see
"Copy From Song" on page 524.
• 5: Load Template Song. For more information, see
"Load Template Song" on page 524.
• 6: Save Template Song. For more information, see
"Save Template Song" on page 525.
• 7: FF/REW Speed. For more information, see
"FF/REW Speed" on page 525
• 8: Set Location (for Locate Key.) For more
information, see "Set Location (for Locate Key)" on
page 525.
• 9: GM Initialize. For more information, see "GM
Initialize" on page 526.
• 10: Copy From Combination. For more
information, see "Copy from Combination" on
page 526.
• 11: Copy From Program. For more information, see
"Copy From Program" on page 526.
• 12: Copy Tone Adjust. This is available only when
Control Assign is set to TONE ADJUST. For more
information, see "Copy Tone Adjust" on page 407.
• 13: Reset Tone Adjust. This is available only when
Control Assign is set to TONE ADJUST. For more
information, see "Reset Tone Adjust" on page 407.
• 12: Copy Scene. This is available only when
Control Assign is set to RT KNOBS/KARMA. For
more information, see "Copy Scene" on page 147.
[Depends on parameter]
[Off, On]
Sequencer P0: Play/REC
• 13: Swap Scene. This is available only when
Control Assign is set to RT KNOBS/KARMA. For
more information, see "Swap Scene" on page 147.
0–9: Control Surface
449
Advertisement
Table of Contents
