5-3: Filter Modulation - Korg Electronic Keyboard Parameter Manual

Intensity
This controls the depth and direction of the Mode 1-2
Crossfade modulation.
Intensity Mod AMS
This selects an AMS source to modulate the intensity of
the main Mode 1-2 Crossfade AMS.
For instance, you can set AMS to use one of the LFOs,
and then set the Intensity Mod AMS to JS -Y. You can
then use the joystick to modulate the amount of the
LFO.
Intensity
This controls the depth and direction of the Intensity
Mod AMS.
5-2c: Manual 1
These parameters let you create your own mix of the
filters. When Mode 1 is set to Manual 1, it will use
these settings.
You may wonder why Band Reject is not included
here. This is because it's not a filter mode per se.
Instead, it's created by an equal combination of High
Pass and Low Pass. Try it and see!

5-3: Filter Modulation

5–3a
5–3b
5–3c
This page contains all of the settings for Filter
Frequency modulation (except for the LFOs, which are
on their own page). Among other things, you can:
• Set up complex keyboard tracking shapes, and
control how the tracking affects filter cutoff.
[–99...+99]
[List of AMS Sources]
[–99...+99]
Program P5: Filter
Lowpass
This controls the volume of the Lowpass filter output.
Negative values invert the phase.
Highpass
This sets the volume of the Highpass filter output.
Bandpass
This controls the volume of the Bandpass filter output.
Dry
This sets the volume of the dry signal.
5-2d: Manual 2
The Manual 2 parameters are identical to those of
Manual 1, as described above.
▼ 5–2: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see "ENTER + 0-9: shortcuts for menu
commands" on page 138.
• 0: Write Program. For more information, see "Write
Program" on page 138.
• 1: Exclusive Solo. For more information, see
"Exclusive Solo" on page 138.
5–3c
• Control the effect of the Filter Envelope on filter
cutoff.
• Assign AMS modulation for filter cutoff.
Filter B is available when the Filter Routing is set to
Serial or Parallel. Otherwise, the parameters for Filter
B will be grayed out.
5-3: Filter Modulation
[–99...+99]
[–99...+99]
[–99...+99]
[–99...+99]
5–3PMC
265