075: Rotary Speaker Pro Od - Korg Electronic Keyboard Parameter Manual

Effect Guide
Horn/Rotor Balance
Sets the level balance between the high-frequency horn
and low-frequency rotor. p.825.
MIC
These settings model a pair of stereo microphones,
recording the rotary speaker.
Microphone
Mic Distance
Rotary Speaker (Top View)

075: Rotary Speaker Pro OD

This is a stereo rotary speaker model, including amp
overdrive and speaker simulation.
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
Left
+
Overdrive
Right
D -mod
On/Off
D -mod
Mode Switch: Rotate/Stop
D -mod
Speed Switch: Slow/Fast
D -mod
Manual Speed Control
CONTROL
These parameters set up modulation to start and stop
the rotary speaker, and to change its speed. This
section is identical to that of the Rotary Speaker effect;
for more information, see "CONTROL" on page 825.
OVERDRIVE
Switch
Switches overdrive on/off.
Source
Selects a modulation source to switch overdrive
on/off.
Mode
This parameter controls how the modulation source
switches the overdrive on and off.
When Mode = Toggle, the overdrive turns on or off
each time you press the pedal or move the joystick. Via
MIDI, overdrive turns on or off each time the
modulation amount exceeds 64.
826
[Rotor, 1...99, Horn]
Rotary Speaker - Mic Placement
Mic Spread
Microphone
Mic Distance
Horn
Horn/Rotor Mic Distance
Rotary Speaker
Mic Spread
Balance
Rotor
Speaker Simulation
[Off...Tempo]
[Toggle, Moment]
Distance
This adjusts the distance between the rotary speaker
and the microphones. Lower values bring the mics
closer to the speaker.
Spread
Sets the angle between the left and right microphones.
Higher settings create a wider stereo effect.
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
When Mode = Moment (short for Momentary), the
overdrive is normally off, and turns on only when you
press the pedal or move the joystick. Via MIDI,
modulation values above 64 turn it on, and values
below 64 turn it off.
Wet / Dry
Gain
Determines the degree of distortion.
Level
Wet / Dry
Sets the overdrive output level.
Tone
Sets the tonal quality of the overdrive.
HORN
These parameters control the speed and acceleration of
the horn. They are identical to those of the Rotary
Speaker effect; for more information, see "HORN" on
page 825.
ROTOR
[Off, On]
These parameters control the speed and acceleration of
the rotor, the volume balance between the horn and
rotor. They are identical to those of the Rotary Speaker
effect; for more information, see "ROTOR" on
page 825.
Speaker Simulator
Speaker Simulator
This part of the effect models the speakers themselves,
creating a slightly warmer tone. Use the check-box to
turn the speaker simulation on or off.
[0...100]
[0...100]
[0...100]
[0...100]
[0...15]
[Check-box]