096: Stereo Bpm Mod. Delay - Korg Electronic Keyboard Parameter Manual

Source
Selects the modulation source of the effect sound's
stereo image width.
Amount
Sets the modulation amount of the effect sound's
stereo image width.

096: Stereo BPM Mod. Delay

This is a stereo modulation delay that lets you
synchronize the delay time to the tempo of the song.
Stereo In - Stereo Out
Left
Delay
Feedback
Delay
Right
Tempo
BPM
Base Note x Times
BPM
Base Note x Times
D -mod
Response L/R: +/+ +/—
LFO: Tri / Sine LFO Shape
LFO Sync
CONTROL
Modulation Mode
Switches between LFO modulation control and
modulation source control.
Dmod Modulation
Reversed L/R control by modulation source. p.833.
Source
Selects the modulation source that controls delay time.
Response
Sets the rate of response to the modulation source.
LFO
Waveform
Selects the LFO Waveform.
Shape
Changes the curvature of the LFO Waveform. p.780.
L LFO Phase [degrees]
Sets the phase obtained when the left LFO is reset.
p.833.
R LFO Phase [degrees]
Sets the phase obtained when the right LFO is reset.
p.833.
Dmod Sync
Switches LFO reset off/on. p.833.
Source
Selects the modulation source that resets the LFO.
[Off...Tempo]
[+/–100]
Wet / Dry
Wet / Dry
D-mod
LFO
LFO Phase Modulation Mode
[LFO, Dmod]
[L/R:+/+, L/R:+/–]
[Off...Tempo]
[0...30]
[Triangle, Sine]
[+/–100]
[–180...+180]
[–180...+180]
[Check-box]
[Off...Tempo]
Delay 096: Stereo BPM Mod. Delay
OUTPUT
This is the standard effects output section, with
modulatable control over wet/dry balance. For more
information, see "OUTPUT" on page 764.
Frequency [Hz]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
MIDI/Tempo Sync
BPM
Base Note
Times
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see "MIDI/Tempo Sync" on
page 777.
Type [Individual, Common1, Common2]
This controls whether the effect uses its individual
LFO, or one of the Common FX LFOs. For more
information, see "LFO Type" on page 777.
Common LFO Phase Offset [degrees]
When Type is set to Common FX LFO 1 or 2, this lets
you offset the phase from the master LFO.
MOD DELAY
BPM
MIDI syncs to the system tempo; 40-240 sets the tempo
manually for this individual effect. p.822.
Time Over? L >
Time Over? R>
The maximum delay time is 1,000msec per channel
(left and right). If the channel's combination of BPM,
Base Note, and Times exceeds this limit, the error
message "OVER!" will appear. If this occurs, change
the delay time parameters so that this message no
longer appears.
L Delay Base Note
Selects the type of notes to specify the left channel
delay time. p.822.
Times
Sets the number of notes to specify the left channel
delay time. p.822.
R Delay Base Note
Selects the type of notes to specify the right channel
delay time. p.822.
[0.02...20.00]
[Check-box]
[MIDI, 40.00...240.00]
[ ... ]
[x1...x32]
[+/–180]
[MIDI, 40.00...240.00]
[---, OVER!]
[---, OVER!]
[ ... ]
[x1...x32]
[ ... ]
845