Installing Additional Sampling Ram (Exb-M256); Precautions; Installation - Korg Pa3X 76-keys User Manual

Installing additional Sampling RAM (EXB-M256)

Pa3X comes equipped with 128MB of Sample RAM already
installed. You can replace the internal RAM with an (optional)
board of 256MB of RAM, for increased sampling space. Korg is
not responsible for any damage or injury caused by incorrect
installation of this module.

Precautions

• Installation of the module is done at the user's own risk. Korg
will assume no responsibility for any damage or injury resulting
from its improper installation or use.
• Be sure to disconnect the instrument from the AC plug, before
opening it.
• To prevent your body's static electricity from damaging the
board's components, touch an unpainted metallic component
before proceeding with the installation.

Installation

For installation, you will need a cross-point screwdriver (not sup-
plied).
From the bottom of the instrument, remove the two fixing
1.
screws (b), and keep them apart. Open the cover (a) to gain
access to the inside of the RAM slot.
2. Before removing the RAM module, slide the switch (d) to
the OFF position, and remove the protective duct tape (e)
from the RAM module (c). Be careful not to tear away the
duct tape from the main board,
3. Then lightly pull out, one after the other, the two securing
clamps (f) (one on each end). After the last one is pushed
Installing additional Sampling RAM (EXB-M256)
out, the RAM module (c) will be released, and will auto-
matically jump out.
4. Insert the new RAM module (g) into the free slot, as shown
in the diagram. Line up the connector side of the module
with the slot base, using the dent between the connectors as
a guide. Then rotate the module down, and delicately push
until the two securing clamps (f) jump back to the locked
position, and the RAM module is firmly seated in place.
253
Precautions