Chapter 78 Telnet Client Command List - D-Link DGS-3120-48PC Reference Manual

xStack
Chapter 78
telnet [<ipaddr> | <ipv6addr>] {tcp_port <value 1-65535>}
78-1 telnet
Description
This command is used to start the telnet client to connect to the specific telnet server. The
parameters specified by the command will only be used for the establishment of this specific
session. They will not affect the establishment of other sessions.
Format
telnet [<ipaddr> | <ipv6addr>] {tcp_port <value 1-65535>}
Parameters
<ipaddr> - The IP address of the telnet server.
<ipv6addr> - The IPv6 address of the telnet server. (EI Mode Only)
tcp_port - (Optional) Specify the telnet server port number to be connected. If not specified, the
default port is 23.
<value 1-65535> - Enter the TCP port number used here. This value must be between 1 and
65535.
Restrictions
None.
Example
Telnet to a Switch by specifying the IP address:
DGS-3120-24TC:admin# telnet 10.90.90.90
Command: telnet 10.90.90.90
DGS-XXXX Fast Ethernet Switch Command Line Interface
Copyright(C) 2006-2009 D-Link Corporation. All rights reserved.
UserName:
®
DGS-3120 Series Managed Switch CLI Reference Guide
Telnet Client Command List
Firmware: Build 1.00.B01
709