Figure 7-164. Static Rp Configuration Page; Table 7-132. Static Rp Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Static RP
Clicking the S
TATIC
(Figure
7-164), which configure static PIM RPs (Rendezvous Points). The parameters
for this page are shown in
Table 7-132. Static RP Configuration Page Parameters
Parameter
Component ID
Address Type
Static Group Address
Static Group Mask
Static RP Address
Figure 7-164. Static RP Configuration Page
RP tab brings up the S
Table
7-132.
Description
This parameter specifies a number uniquely identifying the component.
This parameter chooses the IPv4 or IPv6 address type.
This parameter represents the multicast group, for which the switch
advertises itself as the candidate RP.
This parameter specifies the subnet mask, which when combined with the
group address gives the group prefix.
This parameter represents the IP address of the candidate RP.
RP C
TATIC
ONFIGURATION
7-184
page
Advertisement
Table of Contents
