Stack Link Status; Figure 7-51. Stack Link Status Page - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Table 7-36. Stack Details Page Parameters (Continued)
Parameter
Configured State
Current State
Peer Status – The following parameters display information about all connected stack Slave switches.
Switch ID
Stack IP
Stack MAC
Switch State
Card Name
Stack Link Status
The S
L
TACK
INK
"up" or "down".
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This parameter is used to specify the priority of this switch.
This parameter is used to specify the current status of this switch as
Master or Slave.
This parameter is used to specify the switch identifier of the Slave switch.
This parameter is used to specify the IP address of the Slave switch. This
IP address is used to communicate between stack member switches.
This parameter is used to specify the MAC address of the Slave switch.
This MAC address is used to communicate between stack member
switches.
This parameter is used to specify the current status of the Slave switch.
This parameter is used to specify the type of Slave switch.
Figure 7-51. Stack Link Status Page
S
page
(Figure
TATUS
7-51) displays the stack interface link status as
7-61
Advertisement
Table of Contents
