Rip; Rip Basic Settings; Figure 7-110. Rip Basic Settings Page; Table 7-84. Rip Basic Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
RIP
The RIP link opens the following links for configuration of RIP protocol:
•
"RIP Basic Settings" on page 7-124
•
"Interfaces" on page 7-125
•
"Neighbors List" on page 7-126
•
"Security Settings" on page 7-127
•
"Address Summarization" on page 7-128
RIP Basic Settings
Clicking the B
ASIC
The parameters for this page are shown in
Parameter
Output-delay
Neighbor Filter
Auto-summary status
Figure 7-110. RIP Basic Settings Page
S
tab brings up the RIP B
ETTINGS
Table 7-84. RIP Basic Settings Page Parameters
Description
This parameter specifies the delay that needs to be enabled for RIP to split
the periodic update packets before they are sent out.
This parameter enables or disables neighbor filtering. Neighbor filtering
helps you to filter routes from specific neighbors.
This parameter enables or disables the Auto-summary feature.
S
ASIC
Table
7-84.
7-124
page
(Figure
ETTINGS
7-110).
Advertisement
Table of Contents
