Table 7-105. Bgp Local Preference Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Clicking the L
OCAL
page
(Figure
7-132), which allows you to configure the Local Preference value for
routes. The parameters for this page are shown in
Table 7-105. BGP Local Preference Configuration Page Parameters
Parameter
Local Preference ID
Remote AS
IP Address Prefix
IP Address Prefix Length
Intermediate AS
Direction
Value
Preference
Status
Chapter 7: Layer 2/3 Ethernet Switch Firmware
P
tab brings up the BGP L
REF
Description
This parameter specifies the Local Preference ID, which is the index for
this table.
This parameter specifies the AS number from which the route update is
received.
This parameter specifies the IP Address prefix for which the update is
received.
This parameter is used to calculate the subnet.
This parameter represents the intermediate AS between the BGP peers.
This parameter can be set for the incoming or the outgoing packets using
In and Out values.
This parameter specifies the Local preference value to be associated with
this learnt path.
This parameter is used to enable/disable filtering.
This parameter specifies the status of the entry.
P
OCAL
REFERENCE
Table
7-105.
7-151
C
ONFIGURATION
Advertisement
Table of Contents
