Figure 7-118. Ospf Area Configuration Page; Table 7-91. Ospf Area Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Table 7-90. OSPF Basic Settings Page Parameters (Continued)
Parameter
Autonomous System
Border Router
RFC 1583 Compatibility
External Link State
Database Limit
Area
Clicking the A
REA
The parameters for this page are shown in
Table 7-91. OSPF Area Configuration Page Parameters
Parameter
Area ID
Type
Send Summary Router
Default Cost
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This parameter indicates the flag to denote whether or not the router is to
be configured as an Autonomous System Border Router.
This parameter specifies the compatibility to RFC 1583 for choosing the
route among multiple AS for the same destination.
This parameter specifies the maximum number of non-default
AS-external-LSA entries that can be stored in the link state database.
Figure 7-118. OSPF Area Configuration Page
tab brings up the OSPF A
Description
This parameter specifies the identifier for the area.
This parameter allows you to configure the area type, as a Stub area, a
Normal area or NSSA.
This field is used to control the import of summary LSAs to stub areas. This
does not have any impact for other areas.
This parameter specifies the metric/cost associated with the routes.
C
REA
ONFIGURATION
Table
7-91.
7-133
page
(Figure
7-118).
Advertisement
Table of Contents
