Figure 7-134. Bgp Route Aggregation Configuration Page; Table 7-107. Bgp Route Aggregation Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Route Aggregations
Figure 7-134. BGP Route Aggregation Configuration Page
Clicking the R
OUTE
page
(Figure
7-134), which is used to aggregate and configure the routes advertised by
BGP. The parameters for this page are shown in
Table 7-107. BGP Route Aggregation Configuration Page Parameters
Parameter
ID
IP Address Prefix
IP Address Prefix Length
Route Advertise
Status
Chapter 7: Layer 2/3 Ethernet Switch Firmware
A
tab brings up the BGP R
GGR
Description
This parameter specifies the index to this table.
This parameter specifies the IP address prefix that needs to be
aggregated.
This parameter, in combination with the IP Prefix, decides the aggregated
route to be distributed by this switch.
With this parameter you can either choose to advertise only the
aggregated routes by setting Summary only, or choose to advertise all
routes by setting All.
This parameter specifies the status of the entry.
A
OUTE
GGREGATION
Table
7-107.
7-153
C
ONFIGURATION
Advertisement
Table of Contents
