Rip; Figure 7-139. Rrd Rip Configuration Page; Table 7-112. Rrd Rip Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
RIP
Clicking the RIP tab brings up the RRD RIP C
allows you to re-distribute the routes that are learnt through other routing protocols to
RIP. The parameters for this page are shown in
Table 7-112. RRD RIP Configuration Page Parameters
Parameter
RIP Status
Default Metric
Import
Route Tag Type
Route Tag
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-139. RRD RIP Configuration Page
Description
This parameter enables or disables redistribution for RIP.
This parameter specifies the metric for the routes that are being
re-distributed.
You can use this parameter to choose to import Direct routes, Static routes,
OSPF routes and BGP routes to RIP.
This parameter describes whether a tag is manually configured or
automatically generated.
This parameter indicates the route tag in case you configure a manual
option for the tag type.
ONFIGURATION
Table
7-112.
7-159
page
(Figure
7-139), which
Advertisement
Table of Contents
