Figure 7-162. Candidate Rp Configuration Page; Table 7-130. Candidate Rp Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Table 7-129. PIM Interface Configuration Page Parameters (Continued)
Parameter
CBSR Preference
Row Status
Candidate RPs
Clicking the C
ANDIDATE
(Figure
7-162). The parameters for this page are shown in
Table 7-130. Candidate RP Configuration Page Parameters
Parameter
Component ID
Group Address
Group Mask
RP Address
Description
This parameter indicates the preference value for the local interface as a
candidate bootstrap router.
This parameter indicates the operational status of the entry.
Figure 7-162. Candidate RP Configuration Page
RP
tab brings up the C
S
Description
This parameter specifies a number uniquely identifying the component.
This parameter represents the multicast group, for which the switch
advertises itself as the candidate RP.
This parameter specifies the subnet mask, which when combined with the
group address gives the group prefix.
This parameter represents the IP address of the Candidate-RP.
RP C
ANDIDATE
7-182
page
ONFIGURATION
Table
7-130.
Advertisement
Table of Contents
