Figure 7-133. Bgp Filter Configuration Page; Table 7-106. Bgp Filter Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
BGP Filter
Clicking the F
ILTERS
which is used to set the filters on the routes being learnt. The parameters for this page
are shown in
Table
Table 7-106. BGP Filter Configuration Page Parameters
Parameter
Filter ID
Remote AS
IP Address
IP Address Prefix Length
Intermediate AS
Direction
Action
Status
Figure 7-133. BGP Filter Configuration Page
tab brings up the BGP F
7-106.
Description
This parameter specifies the filter index.
This parameter specifies the remote AS associated with the BGP peer
from which the router is being distributed.
This parameter specifies the IP address for which the route is being learnt.
This parameter specifies the prefix length to calculate the Subnet.
This parameter represents the intermediate AS between the BGP peers.
This parameter indicates the direction of the packet.
With this parameter you can choose either to Allow (not to filter) or Deny
(Filter) for the above configuration set.
This parameter specifies the status of the entry.
C
ILTER
ONFIGURATION
7-152
page
(Figure
7-133),
Advertisement
Table of Contents
