Interface; Virtual Interface; Figure 7-120. Ospf Virtual Interface Configuration Page; Table 7-93. Ospf Virtual Interface Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Table 7-92. OSPF Interface Configuration Page Parameters (Continued)
Parameter
Designated Router
Status
Virtual Interface
Figure 7-120. OSPF Virtual Interface Configuration Page
Clicking the V
IRTUAL
C
ONFIGURATION
Table
7-93.
Table 7-93. OSPF Virtual Interface Configuration Page Parameters
Parameter
Transit Area ID
Neighbor Router ID
Authentication Type
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This read-only field specifies the IP Address of the Designated Router.
When this parameter is enabled, the interface is advertised as an internal
route to some area. When disabled it denotes that the interface is external
to OSPF.
I
tab brings up the OSPF V
NTERFACE
page
(Figure
7-120). The parameters for this page are shown in
Description
This parameter specifies the transit area that the virtual link traverses.
This parameter specifies the router ID of the virtual neighbor.
This parameter allows you to choose MD5, Simple Password or None as
the authentication type.
IRTUAL
7-135
I
NTERFACE
Advertisement
Table of Contents
