Figure 7-42. Qos Classmap Settings Page; Table 7-29. Qos Basic Settings Page Parameters; Table 7-30. Qos Classmap Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Table 7-29. QOS Basic Settings Page Parameters
Parameter
System Control
Status
QOS Classmap Settings
Clicking the C
LASSMAP
which is used to classify the stream of traffic. The parameters for this page are shown in
Table
7-30.
Table 7-30. QOS Classmap Settings Page Parameters
Parameter
Classmap ID
Filter ID
Filter Type
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
With this parameter S
This parameter allows enabling/disabling of the QoS status.
Figure 7-42. QOS Classmap Settings Page
tab brings up the QOS C
Description
This parameter specifies a unique ID for the Classmap. It must be in the
range from 1 to 65535.
This parameter specifies the unique filter ID associated with this
Classmap.
This parameter specifies the filter type associated with the Classmap. It
can be set as either MAC filter (1) or IP filter (2).
C
can Start or Shutdown QoS.
YSTEM
ONTROL
S
LASSMAP
7-49
page
(Figure
ETTINGS
7-42),
Advertisement
Table of Contents
