Static Management Ip Address Configuration - Supermicro SSE-G48-TG4 Configuration Manual

manage blade switches through front panel switching ports, configure a layer 3 VLAN interface with the
required IP address.
Defaults – Management IP
Parameter
IP Address
Broadcast Address
Gateway

1.1.1 Static Management IP Address Configuration

The IP address command can be used to manually configure the management interface IP address.
Follow the steps below to manually configure the management interface IP address.
Step Command
configure terminal
Step 1
Step 2 ip address [<ip-address> | <ip-address>/prefix-
length] [<subnet-mask>]
Step 3 end
Step 4 show ip interface
The manual IP address configuration is saved automatically as part of the start-up config.
The "no ip address" command resets the switch IP address to 0.0.0.0.
The example below shows the commands used to configure the management interface IP address
manually.
SMIS# configure terminal
SMIS(config)# ip address 192.168.1.10
SMIS(config)# end
Default Value
192.168.100.102
255.255.255.255
0.0.0.0
Supermicro L2/L3 Switches Configuration Guide
Description
Enters the configuration mode.
Configures the management interface
IP address manually.
ip-address – A valid IPv4 Address.
ip-address/prefix-length - A valid IPv4
Address with a prefix length value of 1-
32.
subnet-mask – A valid IP subnet mask.
Exits the configuration mode.
Displays the management interface IP
configuration.
7