Figure 7-135. Advanced Bgp Configuration Page; Table 7-108. Advanced Bgp Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Advanced BGP Configuration
Clicking the A
DVANCED
(Figure
7-135), which configures dampening and confederation parameters. The
parameters for this page are shown in
Table 7-108. Advanced BGP Configuration Page Parameters
Parameter
Client to Client Reflection
Dampening Half Life Time
Dampening Reuse Value
Dampening Suppress
Value
Figure 7-135. Advanced BGP Configuration Page
tab brings up the A
Description
This parameter configures the Route Reflector to support route reflection
to client peers.
By default, the Route Reflector will reflect routes learnt from a client peer to
all other client peers. If required, the administrator can disable this feature
by disabling client-to-client reflection.
If disabled, then the Route Reflector will not advertise routes learnt from a
client peer to other client peers. This occurs when all peers within a cluster
are fully-meshed and the client peer itself is able to advertise routes to
other clients of the route-reflector.
This parameter specifies the time (in seconds) after which a penalty is
decreased by half. Once a route has been assigned a penalty, the penalty
is decreased by half after the half-life time.
If the penalty associated with a suppressed route falls below this value, the
route is re-used.
A route is suppressed when the penalty associated with the route exceeds
this value.
BGP C
DVANCED
Table
7-108.
7-154
page
ONFIGURATION
Advertisement
Table of Contents
