Port Control; Figure 7-59. Port Control Page; Table 7-41. Port Control Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Port Control
Clicking the P
ORT
allows you to configure specific parameters of the port. You can choose between
Auto-negotiation and No-negotiation for a port. If No-negotiation is chosen, then the
speed of the link, FlowControl and duplex modes can be configured. The parameters for
this page are shown in
Parameter
Port
Mode
Duplex
Speed
Flow Control Admin Status
Flow Control Operation
Status
HOL Block Prevention
Figure 7-59. Port Control Page
C
tab brings up the P
ONTROL
Table
7-41.
Table 7-41. Port Control Page Parameters
Description
This displays the port number.
This parameter allows you to select either Auto Negotiation or
No-negotiation.
This parameter allows you to select either Full Duplex or Half Duplex.
This parameter allows you to select the speed as 10 Mbps, 100 Mbps or
1 Gbps.
This parmeter allows you to specify the Flow Control Admin Status as
either Disabled, Trasmit Flow Control Enabled, Receive Flow Control
Enabled or both Transmit and Receive Flow Control Enabled.
This parameter displays the status of the flow control.
This parameter allows you to enable or disable Head of Line block
prevention.
C
ORT
ONTROL
7-70
page
(Figure
7-59), which
Advertisement
Table of Contents
