RSTP
The RSTP link provides links to the following configuration pages:
•
"RSTP Global Settings" on page 7-83
•
"RSTP Basic Settings" on page 7-84
•
"Port Settings" on page 7-85
•
"Port Status" on page 7-86
RSTP Global Settings
Clicking the G
LOBAL
(Figure
7-72), which allows you to configure RSTP global parameters. The parameters
for this page are shown in
Table 7-50. Global Configuration Page Parameters
Parameter
System Control
Status
Dynamic Path Cost
Calculation
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-72. Global Configuration Page
S
tab brings up the G
ETTINGS
Table
7-50.
Description
This parameter starts or Shutsdown RSTP in the switch.
This parameter allows you to enable/disable the protocol at a global level
on the switch.
This parameter allows you to enable or disable the D
C
.
ALCULATION
7-83
C
LOBAL
ONFIGURATION
YNAMIC
page
P
C
ATH
OST