Figure 7-149. Igmp Snooping Timer Configuration Page; Table 7-119. Igmp Snooping Timer Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Table 7-118. IGMP Snooping Configuration Page Parameters (Continued)
Parameter
Retry Count
Query Transmit On TC
IGMP Snooping Timer
Figure 7-149. IGMP Snooping Timer Configuration Page
Clicking the T
IMER
(Figure
7-149), which configures IGMP snooping timers. The parameters for this page
are shown in
Table
Table 7-119. IGMP Snooping Timer Configuration Page Parameters
Parameter
Router Port PurgeInterval
(Secs)
Group-Member Port Purge
Interval (Secs)
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This parameter specifies the maximum number of group specific queries
sent on a port on the reception of an IGMPv2 leave message.
This parameter allows you to enable or disable query transmit when
topology changes.
tab brings up the IGMP S
7-119.
Description
This parameter specifies the interval for which the learnt router port will be
purged. The default value is 125-seconds.
This parameter specifies the interval after which a port gets deleted, if
IGMP reports are not received on a port. The default value is
260-seconds.
T
NOOPING
IMER
7-169
C
page
ONFIGURATION
Advertisement
Table of Contents
