Figure 7-198. Ospf Link State Database Page; Table 7-166. Ospf Link State Database Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Table 7-165. OSPF Route Information Page Parameters (Continued)
Parameter
Type 2 Cost
Interface
OSPF Link State DB
Clicking the L
INK
(Figure
7-198), which displays information about OSPF link state database. The
parameters for this page are shown in
Table 7-166. OSPF Link State Database Page Parameters
Parameter
Area ID
Type
Link State ID
Router ID
Sequence
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Description
This parameter specifies the Type 2 cost.
This parameter specifies the interface.
Figure 7-198. OSPF Link State Database Page
S
D
tab brings up the OSPF L
TATE
ATABASE
Description
This parameter specifies the area identifier.
This parameter specifies the link state type.
This parameter specifies the link state identifier.
This parameter specifies the router identifer.
This parameter specifies the sequence number of this link state
information.
Table
7-166.
7-231
S
D
INK
TATE
ATABASE
page
Advertisement
Table of Contents
