Static Rp - Supermicro SSE-X3348T/R User Manual

1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User's Manual

Static RP

Clicking the S
TATIC
(Figure 5-153), which configure static PIM RPs (Rendezvous Points). The parameters
for this page are shown in
Table 5-130. Static RP Configuration Page Parameters
Parameter
Component ID
Address Type
Static Group Address
Static Group Mask
Static RP Address
Figure 5-153. Static RP Configuration Page
RP tab brings up the S
Table 5-130.
Description
This parameter specifies a number uniquely identifying the component.
This parameter chooses the IPv4 or IPv6 address type.
This parameter represents the multicast group, for which the switch advertises
itself as the candidate RP.
This parameter specifies the subnet mask, which when combined with the group
address gives the group prefix.
This parameter represents the IP address of the candidate RP.
RP C
TATIC ONFIGURATION
5-180
page