Figure 7-160. Pim Component Configuration Page; Table 7-128. Pim Component Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
Table 7-127. PIM Basic Settings Page Parameters (Continued)
Parameter
Registration Stop Rate
Limiting Period
PMBR Status
Static RP
Component
Clicking the C
OMPONENT
(Figure
7-160). The parameters for this page are shown in
Table 7-128. PIM Component Configuration Page Parameters
Parameter
Component ID
Candidate CRP Hold Time
Mode
Description
This parameter specifies the registration stop rate limiting period in
seconds.
This parameter allows you to enable or disable the PMBR status in the
switch.
This parameter allows you to enable or disable the Static RP in the switch.
Figure 7-160. PIM Component Configuration Page
tab brings up the PIM C
Description
This parameter specifies a number uniquely identifying the component.
This parameter specifies the hold time of the component when it is a
candidate RP in the local domain.
This parameter specifies the mode of the component. It can be Sparse or
Dense.
OMPONENT
7-180
C
page
ONFIGURATION
Table
7-128.
Advertisement
Table of Contents
