1/10-Gigabit Ethernet Module Led Descriptions; Table B-2. 1/10 Gigabit Ethernet Switch Led Indicators - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
B-2
1/10-Gigabit Ethernet Module LED Descriptions
The 1/10-Gbps Ethernet modules and SBM-XEM-002/M 10GbE Pass-through Module
LEDs are described below in
Table B-2. 1/10 Gigabit Ethernet Switch LED Indicators
LED
RJ45 Link/Activity
(GEM-X2C+/X3S+
modules)
RJ45 Speed
(GEM-X2C+/X3S+
modules)
"Initiation OK" LED
Module Fault LED
10G Port LEDs
Stack ID LEDs
(GEM-X2C Module Only)
Table
B-2.
State
Description
Solid denotes link established, no activity. Blinking
Green
denotes activity. Off indicates that no link is established.
Amber denotes 1-Gbps speed.
Amber/Green/
Green denotes 100 Mbps speed.
Off
Off denotes 10 Mbps speed.
Blue
Denotes successful initiation/OK status when solidly lit.
Red
Denotes module failure when solidly lit.
Denotes activity for 10-Gbps port when solidly lit. Blinking
Green
green denotes data transmited (Tx) or received (Rx).
Green
Denotes Stack ID activity as shown in
B-2
Table B-3
below.
Advertisement
Table of Contents
