Figure 7-146. Vrrp Settings Page; Table 7-117. Vrrp Settings Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Superblade Network Modules User's Manual
VRRP Settings
Clicking the VRRP S
The parameters for this page are shown in
Parameter
Virtual Router ID
Interface
Primary IP Address
Priority
Authentication Type
Authentication Key
Advertisement Interval
(Seconds)
Preempt Mode
State
Status
Figure 7-146. VRRP Settings Page
link brings up the VRRP S
ETTINGS
Table 7-117. VRRP Settings Page Parameters
Description
This parameter indicates the Virtual ID associated with each Virtual Router.
This parameter represents the interface on which the Virtual Router must
be configured.
This parameter specifies the P
This parameter indicates the P
configurable priority value ranges from 1 to 254.
This parameter indicates the A
This parameter indicates the A
This parameter specifies the time Interval in seconds for sending the
advertisement packets.
This parameter enablesor disables the P
This parameter indicates the current state of the Virtual Router.
This parameter specifies the Admin Status of the Virtual Router.
ETTINGS
Table
7-117.
IP A
RIMARY
for the Virtual Router. The
RIORITY
UTHENTICATION
UTHENTICATION
REEMPT
7-166
page
(Figure
7-146).
for the Virtual Router.
DDRESS
T
for the Virtual Router.
YPE
K
for the Virtual Router.
EY
M
.
ODE
Advertisement
Table of Contents
