Figure 7-74. Port Status Configuration Page; Table 7-52. Port Status Configuration Page Parameters - Supermicro SuperBlade Series User Manual
Network modules, 1/10-gbps ethernet switch module, 4x qdr infiniband switch module, 10-gbps ethernet pass-through module, 1-gbps ethernet pass-through module for twinblade, 4x ddr infiniband pass-through module
Table of Contents
Advertisement
Port Settings
Clicking the P
ORT
(Figure
7-74), which allows you to set the configuration per port related to RSTP. The
parameters for this page are shown in
Table 7-52. Port Status Configuration Page Parameters
Parameter
Port
Status
Priority
Path Cost
Protocol Migration
PortFast
Point-to-Point
Auto Edge Status
Chapter 7: Layer 2/3 Ethernet Switch Firmware
Figure 7-74. Port Status Configuration Page
S
tab brings up the P
ETTINGS
Description
This parameter specifies the port identifier.
This parameter enables or disables the RSTP protocol status on a
particular port.
This parameter specifies the port priority used in role selection.
This parameter specifies the path cost associated with this port.
This parameter controls the migration from RSTP to STP, if the other side
of the switch runs STP. The migration takes place only if this is Enabled.
This parameter must be configured, if the corresponding port is an edge
port.
This parameter allows you to configure ports explicitly as Point-to-point
(Force true), Non-point-to-point or leave the decision to be made
Dynamically (from the AL or MAC layer).
If this parameter is set to true, the edge port status is dynamically
calculated.
S
ORT
TATUS
Table
7-52.
7-85
C
page
ONFIGURATION
Advertisement
Table of Contents
